Curved Trade Show Booth

Sets Up in 10 Minutes or Less

Remove the pieces from the included carrying case and set on the floor to begin set up.

Raise until the frame is in its fully upright position. We have also found that this step may be easier by
placing the frame on the ground. If you decide to setup your frame this way, make sure you place a protective
material on the floor or the Velcro® may damage your rug.

Connect all of the hooks in the frame as shown above right. This will keep your frame from collapsing.
Next, add the curved side bars to the sides of the frame. You will see small metal pieces where they attach.
Attach one side of the curved bar to the frame and then stretch the bar so it connects to the other side.
Make sure the pieces line up correctly and snap together securely. This will give your display its curved shape.

Note: When breaking down your frame, you MUST make sure all of the hooks are unclasped.
If you try to collapse your frame when even some of the hooks are still together, you risk breaking the frame.

Next, unroll the black end caps - they will come with Velcro® strips already attached so that you can connect them to the
Velcro® strips on the frame. Wrap each of the end caps around the curved pieces on the sides of the frame, and
attach. Make sure that the Velcro® strips on the back side of each end cap is placed in the back of the frame.
See above right. This is where your fabric will wrap around and attach.

Now attach your graphics to the frame; this is easiest done by laying the frame down on the ground.
Your graphics come with Velcro® receptive strips sewn to the back edges that connect to the Velcro® strips on the frame.
Attach the fabric to the top and bottom of the frame, and then wrap the fabric around to the Velcro® strips located
on the sides of the frame. See picture above.

After your graphics are installed you can install the optional floodlights. Lights can only be installed at the intersection of two horizontal frame poles. Make sure the channels on the bottom of the light clip are seated on the poles and firmly snapped into place. After the clip is attached to the frame, slide the light onto the channels in the clip. See picture above left.

Graphics Care: Your graphics can be spot cleaned with mild soap and warm water. A product like
"Spray and Wash" may be used for spot cleaning as well. Be gentle as scrubbing may damage the graphic or fabric.
We also recommend trying the spot cleaner on a small location in the corner before using on larger areas.
DO NOT DRY CLEAN!